Skip to content
Unable to connect to VPN, disconnected after 1-2 seconds
Got a problem with Viscosity or need help? Ask here!
Hi MikeSK,
More information will be available in the OpenVPN log:
https://www.sparklabs.com/support/kb/ar ... envpn-log/
If you need help resolving the issue, please post a copy of your log and we'll take a look. Please feel free to remove any sensitive details before posting it.
Cheers,
James
More information will be available in the OpenVPN log:
https://www.sparklabs.com/support/kb/ar ... envpn-log/
If you need help resolving the issue, please post a copy of your log and we'll take a look. Please feel free to remove any sensitive details before posting it.
Cheers,
James
Web: https://www.sparklabs.com
Support: https://www.sparklabs.com/support
Twitter: https://twitter.com/sparklabs
Support: https://www.sparklabs.com/support
Twitter: https://twitter.com/sparklabs
Hi MikeSK,
Thanks for sending that. I think we've found the problem and implemented a fix. Could you please try updating to 1.8.5 Beta 8 and let us know if the problem is still present?
Regards,
Eric
Thanks for sending that. I think we've found the problem and implemented a fix. Could you please try updating to 1.8.5 Beta 8 and let us know if the problem is still present?
Regards,
Eric
Eric Thorpe
Viscosity Developer
Web: http://www.sparklabs.com
Support: http://www.sparklabs.com/support
Twitter: http://twitter.com/sparklabs
Viscosity Developer
Web: http://www.sparklabs.com
Support: http://www.sparklabs.com/support
Twitter: http://twitter.com/sparklabs
Eric, thanks for your quick reply!
However, despite the update, I still cannot connect. What's different this time are new error messages. In fact, there is only one, repeating over and over.
Log file attached.
Mike
However, despite the update, I still cannot connect. What's different this time are new error messages. In fact, there is only one, repeating over and over.
Log file attached.
Mike
Attachments
soft1Log.txt
(1.36 KiB) Downloaded 453 times
Hi MikeSK,
Could you please open a Command Prompt and send us the output of the following two commands? Type each one in then press Enter:
ipconfig -all
route print
You may wish to email these to us instead as this is a public forum - https://www.sparklabs.com/support/#contact
Regards,
Eric
Could you please open a Command Prompt and send us the output of the following two commands? Type each one in then press Enter:
ipconfig -all
route print
You may wish to email these to us instead as this is a public forum - https://www.sparklabs.com/support/#contact
Regards,
Eric
Eric Thorpe
Viscosity Developer
Web: http://www.sparklabs.com
Support: http://www.sparklabs.com/support
Twitter: http://twitter.com/sparklabs
Viscosity Developer
Web: http://www.sparklabs.com
Support: http://www.sparklabs.com/support
Twitter: http://twitter.com/sparklabs
6 posts
Page 1 of 1