Skip to content
OpenVPN Version per Configuration
Got a problem with Viscosity or need help? Ask here!
Sorry if this has been asked. I didn't find anything specifically related, though.
Is there a way to set the OpenVPN version under Advanced PER configuration rather than globally? I have a work VPN that just does not seem to work unless this is set to 2.3. However, I have a home VPN running 2.4. My home VPN connection seems to work fine with the version set to 2.3, but the purist in me would rather each connection match the server.
Is there a way to set the OpenVPN version under Advanced PER configuration rather than globally? I have a work VPN that just does not seem to work unless this is set to 2.3. However, I have a home VPN running 2.4. My home VPN connection seems to work fine with the version set to 2.3, but the purist in me would rather each connection match the server.
Hi slakr007,
The version can be overridden on a connection-by-connection basis by using the “#viscosity protocol-version” advanced command, for example "#viscosity protocol-version 2.3”. For information on how to specify advanced commands please see:
https://www.sparklabs.com/support/kb/ar ... n-commands
However, OpenVPN 2.4 is fully backwards compatible with OpenVPN 2.3, so I do recommend getting your connection to work using version 2.4 instead. The most common problem to run into is compression setting differences, which the following article should help with:
https://www.sparklabs.com/support/kb/ar ... ader-byte/
Cheers,
James
The version can be overridden on a connection-by-connection basis by using the “#viscosity protocol-version” advanced command, for example "#viscosity protocol-version 2.3”. For information on how to specify advanced commands please see:
https://www.sparklabs.com/support/kb/ar ... n-commands
However, OpenVPN 2.4 is fully backwards compatible with OpenVPN 2.3, so I do recommend getting your connection to work using version 2.4 instead. The most common problem to run into is compression setting differences, which the following article should help with:
https://www.sparklabs.com/support/kb/ar ... ader-byte/
Cheers,
James
Web: https://www.sparklabs.com
Support: https://www.sparklabs.com/support
Twitter: https://twitter.com/sparklabs
Support: https://www.sparklabs.com/support
Twitter: https://twitter.com/sparklabs
I ran into that compression article before. Not sure what I did the first time around, but this time I started with a clean version of the client configuration from work and carefully changed one thing at a time. I think the client configuration was borked from the start since it specified `comp-lzo no` but deleting that and setting compression to LZO in the options works with the OpenVPN version set to Automatic.
So, seems like it's all good now! Thanks, James.
So, seems like it's all good now! Thanks, James.
3 posts
Page 1 of 1