Config on the command line
Posted: Tue Dec 12, 2017 4:11 pm
Hi,
I'm trying to configure the inactivity timeout via the command line on the mac client.
I have tried using the defaults command, and it successfully puts in the values that I want (IdleTime = 60; and DisconnectOnIdle = 1) but the GUI of viscosity never shows the changes. If I go into the GUI and check the box and set the idle timeout, it changes in the plist file and works. For some reason, when I make the changes to the plist file with defaults, it doesn't actually do anything. I've tried killing the process and restarting it, but viscosity doesn't pick up the changes.
Any ideas?
I'm trying to configure the inactivity timeout via the command line on the mac client.
I have tried using the defaults command, and it successfully puts in the values that I want (IdleTime = 60; and DisconnectOnIdle = 1) but the GUI of viscosity never shows the changes. If I go into the GUI and check the box and set the idle timeout, it changes in the plist file and works. For some reason, when I make the changes to the plist file with defaults, it doesn't actually do anything. I've tried killing the process and restarting it, but viscosity doesn't pick up the changes.
Any ideas?